Product Features 1, the heat transfer part of the improved fast heat exchanger, heat transfer coefficient than leave, heat capacity, the same volume of the heat exchange of the product were equivalent to conventional volume heat exchanger 5-8 times . 2, the characteristics of which half volume, making storage a storage part amount of hot water for 10-20 minutes, the heated water head loss <= 0.2 m, so it set the general conditions of automatic temperature control valve still to maintain water pressure, water temperature stable, safe, water, water comfort. 3, the heating part of the fast type, all of the hot water storage tank, no stagnant water, cold water area, volume utilization rate of 100%. 4, the product is little or no water, can help online circulation pump hot water pipe work to maintain the tank water temperature, heat transfer part of the total water flow in the heated state, so that the full heat, energy, soft drinks when the condensate heat exchanger water temperature below 80 degrees. Pot water, light, heat exchanger bundles out along the horizontal direction, easy maintenance, and is installed into the hole, to periodically check the internal condition. Designed to use 1, the series of heat exchangers for general industrial and civil water supply systems, steam or heat to high and low temperatures softened water, according to different heat source selection. 2, the heated water outlet temperature not higher than 75 degrees, the actual use, the delay scale, temperature should be controlled to be heated at 50-60 ° before. In order to run more secure. HTM shall be installed on the outlet pipe trap. 3, Material: This series of heat exchangers recommend using stainless steel shell material: Ocr18Ni9 or imported stainless steel plate SUS304; beam tubes using T2 copper material and stainless steel pipe. If users do not ask for water, also made of carbon steel and carbon steel shell beam tubes. 4, HRV-01 product is H = 400mm steel saddle supports, HRV-02 uses only the deck supports, there are special requirements for product installation, the user needs to change the seat height can be. 5, the heat exchanger should be installed safety devices. Installation of safety valve, the valve opening pressure should not exceed the design pressure (safety valve should be affirmed Order), the safety valve installation and use shall comply with the Ministry of Labor and Personnel "Pressure Vessel Safety Supervision Regulations" requirement.